We will also service in other US
states, Canada and specific European countries, travel cost permitting
We provide ballscrew repair
CNC fabrication and machining equipment.
We provide field service ballscrew
repair to ensure the least downtime and the least lost production. Even
with travel expenses our prices are lower than most repair depot
estimates/invoicing. See Pricing Page for
Accuracy restoration does not have
to be expensive. It just has to be right!
We provide cost effective field
service repair of worn, loose and noisy ball screw assemblies.
Most CNC metal working machines tend to loosen up with age and
production hours. It is very common to see laser machines with only
4,000 to 6,000 hours on them show hole out-of-round problems. It is
not a machinery quality problem that causes this. Abrasive
cutting effluents suspended in the air and blown around by the assist
gas causes the problem. The dust is very fine and tends to coat
everything, on or near the machine.
When this dust settles on the oil covered ball screws it forms a grinding paste.
After a while, assembly wear is the result over time
CNC punching machines have a more forgiving environment but have open motion systems to shop dirt. They can go 8,000 to 10,000 hours before position errors show up.
CNC machining centers and lathes can go allot longer. The problem shows up as tool chatter, loss of stiffness, interpolation errors and poor finish pass accuracy.
90% of these machines can be repaired without expensive
new assembly replacement, downtime and regrinding!
Our message is simple: When we fix them, it is not expensive if we can
clean, repair & service them before failure.
CALL US WHEN THEY GET LOOSE OR NOISY,
BEFORE THEY SEIZE UP.
YOU SAVE BIG BUCKS
On the repairs and keep total downtime to a minimum!
Copyright � 2001-2004 - Richardson Precision, Inc. - All Rights Reserved